Polypropylene Grid Fill For Replacement In Cooling Towers

Opportunity Summary

Cooling tower contact fill, composed by blocks of inject molded polypropylene grids.

 Due to its configuration this fill is widely used for industrial waters even when the water is contaminated with suspended solids. Chemical treatment for biological control is always recommended. Due to its very low clogging characteristic, it is the most recommended fill for power plants, alcohol distilleries, chemical and petrochemical plants, heat exchangers applications in general. Each grid is injected with 300 x 300 mm and 2.5 mm average thickness. The grid has waves with 12 mm high. The block is formed by snapping together male/female buttons which are injected along the grid body. There are no steel or plastic rods to assemble the block. The typical block is formed by 12 level of grids and has the following dimensions: Width: 300 mmHeight: 300 mmLength: 1.200 mm Usually the maximum fill height to apply in a counter flow tower is 2.100 mm depending on the design data and water quality.This fill media is intended to cooling tower used in power, petrochemical, steel mills, industries.Due to the low clogging characteristic the pp grid fill block can operate with industrial waters with very good tolerance to suspended solids.Each block has the following dimensions: 300x300x1.200 mm. Special length can also be ordered in 200 mm increments